Toshiba e-STUDIO556 - Page 372

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
6 - 8
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size1 3:Short size 4:Post card
(*2) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size1 of OHP film
3: Short size 2 of OHT film 4:Post card size of OHP film
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-239 mm (8.7-12.9 inches)
Short size1: 205-219 mm (8.1-8.6 inches)
Short size2: 160-204 mm (6.3-8.0 inches)
Post card: 159 mm or shorter (6.2 inches or shorter)
2. The adjustment of “Post card” is for Japan only.
<Procedure>
(1) Perform the test print according to the following procedure.
Paper
type
Weight
1st
drawer
2nd
drawer
3rd
drawer
4th
drawer
Tandem
LCF
Duplexing
(ADU)
Option
LCF
Bypass
feed(SFB)
Plain
paper
60-80 g/m
2
17-20 lb.
4100
(*1)
4101
(*1)
4108
(*1)
4109
(*1)
4111 4110 (*1) - 4103 (*1)
Thick
paper 1
81-105g/m
2
21-28 lb.
4115
(*1)
4116
(*1)
4117
(*1)
4118
(*1)
4119-0 4120 (*1) - 4104 (*1)
Thick
paper 2
106-163g/m
2
29-43 lb.
----4119-1- -4105 (*1)
Thick
paper 3
164-209g/m
2
44-55 lb.
----4119-2- -4106 (*1)
OHP - ----4119-3- -4107 (*2)
(*3)1: Single-sided grid pattern 3: Double-sided grid pattern 6: Gamma check patch chart for
copia (black) (Same as 04-103) 10: Gamma adjustment patch chart for copia (black) (Same 04-
101)
(2) Check if any transfer void is occurring. If
there is a transfer problem, try the values in
descending order as “31”  “30”  “29”···
until the transfer void disappears. At the
same time, confirm if any paper jam occurs.
Also, when the aligning amount has been
increased, this may increase the scraping
noise caused by the paper and the Mylar
sheet as it is transported by the registration
roller. If this scraping noise is annoying, try to
decrease the value.
Fig. 6-12
(Code) [START] (Sub-code) [START]
[0][5]
[Power]
Current value
displayed
Enter new
value
[POWER]
OFF/ON
(Exit)
[Drawer
selection]
(*3) +[FAX]
(Test print)
[OK] or
[INTERRUPT]
Stores in memory
(Not necessary for LCF)
50mm - 100mm
Transfer void