e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
6 - 18
[C] Image position adjustment of the primary scanning direction
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
(2) Place a ruler on the original glass with its leading edge pushed against the rear side and its side
along the original scale on the left.
(3) Press [FAX] [START] to make a copy at the mode of A3 (LD), 100% and the 2nd drawer.
(4) Measure the distance B from the left edge of the paper to 100 mm of the copied image of the
ruler.
(5) Check if the distance B is within the range of 100±1.0 mm.
(6) If not, use the following procedure to change values and repeat the steps (3) to (5) above.
(Adjustment Mode) (Key in the code [3030]) [START]
(Key in a value (acceptable values: 63 to 193))
Press the [OK] or the [INTERRUPT] button (stored in memory).
(“100% A” is displayed.)
* The smaller the adjustment value is, the more the image is shifted to the left and the distance
B becomes narrower (approx. 0.04 mm/step).
Fig. 6-18
50 100 150 200
B
Feeding direction
Copied image of the ruler
To Next Page
Loading...
