Toshiba TECRA A11 Series User Manual

Tests and Diagnostics
3-106 [CONFIDENTIAL] TECRA A11/S11/P11/Satellite Pro S500 Series Maintenance Manual (960-784)
3.34.4.3 Test Procedure
This section describes operation procedure of WinPE T&D.
1) Select the test item to run from Test Item and check it. (If you put a check mark in the
ALL Item Check check box, all test items are checked.)
2) Select the test mode of each test.
(If you put a check mark in the ALL Detail Check check box, all tests are performed in the
Detail mode.)
3) Set the number of LOOP CONT, Multitask and CPU Stress.
4) Click on the [START] button and the test starts.
5) When "Multitask" is checked and a test is started, the test of Keyboard and Mouse is done
once first. Next, other tests are started.
6) If PASS of each test reaches the value set to [LOOP COUNT] the number of pass times,
the test is terminated, or if the [STOP] button is clicked, the test is terminated
Note: The test item grayed out indicates that the test is not ready yet and you cannot select
it.

Toshiba TECRA A11 Series Specifications

General

RAM	Up to 8GB DDR3
Operating System	Windows 7 Professional
Battery Life	Up to 4 hours
Optical Drive	DVD SuperMulti Drive
LAN	Gigabit Ethernet
Processor	Intel Core i3, i5, or i7
Display	15.6-inch HD (1366x768)
Storage	HDD up to 500GB
Graphics	Intel HD Graphics
Wireless	802.11 a/g/n
Webcam	Integrated webcam
Ports	USB 2.0, VGA, RJ-45
Card Reader	SD
Battery	6-cell Li-ion
Dimensions	374 x 250 mm
Chipset	Mobile Intel QM57 Express Chipset