TP-Link TL-SG5412F

30
switchport voice-vlan mode
Description
The switchport voice-vlan mode command is used to configure the Voice
VLAN mode for the Ethernet port.
Syntax
switchport voice-vlan mode { manual | auto }
Parameter
manual / auto —— Port mode.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure Ethernet port 2 to operate in the manual voice VLAN mode:
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# switchport voice-vlan mode manual
switchport voice-vlan security
Description
The switchport voice-vlan security command is used to configure the Voice
VLAN security mode.
Syntax
switchport voice-vlan security {disable | enable}
Parameter
disable / enable —— disable/enable the security mode for the specified port .
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable Ethernet port 2 for the Voice VLAN security mode:
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# switchport voice-vlan security enable