107
Parameter
start-date —— The start date of DST you set.
start-time —— The start time of DST you set.
end-date —— The end date of DST you set.
end-time —— The end time of DST you set.
Command Mode
Global Configuration Mode
Example
Configure the dst, dst is from April 1 00:00 to November 1 23:00.
TP-LINK(config)# system-time dst 04/01 00:00 11/01 23:00
ip address
Description
The ip address command is used to configure the IP Address, Subnet Mask
and Default Gateway. To restore to the factory defaults, please use no ip
address command.
Syntax
ip address {ip-addr} {ip-mask} [gateway]
no ip address
Parameter
ip-addr —— The system IP of the Switch. The default system IP is 192.168.0.1.
ip-mask —— The Subnet Mask of the Switch. The default Subnet Mask is
255.255.255.0.
gateway —— The Default Gateway of the Switch. By default, it is empty.
Command Mode
Global Configuration Mode
Example
Configure the system IP as 192.168.0.69 and the Subnet Mask as
255.255.255.0:
TP-LINK(config)# ip address 192.168.0.69 255.255.255.0
To Next Page
Loading...
Need help?
General
Weight and Dimensions
