40
Chapter 9 LAG Commands
LAG (Link Aggregation Group) is to combine a number of ports together to make a single
high-bandwidth data path, which can highly extend the bandwidth. The bandwidth of the LAG is
the sum of bandwidth of its member port.
interface link-aggregation
Description
The interface link-aggregation command is used to access the Interface
Link-aggregation Mode. To delete the aggregation group, please use no
interface link-aggregation command.
Syntax
interface link-aggregation group-number
no interface link-aggregation group-number
Parameter
group-number ——The LAG number, ranging from1 to 14.
Command Mode
Global Configuration Mode
Example
Access the Interface Link-aggregation Mode and configure the aggregation
group 1:
TP-LINK(config)# interface link-aggregation 1
TP-LINK(config-if)#
interface range link-aggregation
Description
The interface range link-aggregation command is used to access the
Interface range Link-aggregation Mode, and you can configure some
aggregation groups at the same time. To delete the aggregation group, please
use no interface range link-aggregation command.
To Next Page
Loading...
