TP-Link TL-SG5412F

45
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable LACP protocol on the port 1:
TP-LINK(config)# interface ethernet 1
TP-LINK(config-if)# lacp
lacp admin-key
Description
The lacp admin-key command is used to configure the admin key. To restore to
the default value, please use no lacp admin-key command.
Syntax
lacp admin-key value
no lacp admin-key
Parameter
value —— admin key, ranging from 0 to 65535. By default, the value is 1.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the admin key of port 1 as 1024:
TP-LINK(config)# interface Ethernet 1
TP-LINK(config-if)# lacp admin-key 1024
lacp port-priority
Description
The lacp port-priority command is used to set the priority of the current port. To
restore to the default priority, please use no lacp port-priority command.
Syntax
lacp port-priority value
no lacp port-priority