TP-Link TL-SG5412F

122
Example
Display the configurations of port5:
TP-LINK# show interface configuration ethernet 5
show interface status
Description
The show interface status command is used to display the connective-status
of an Ethernet port.
Syntax
show interface status ethernet [interface]
Parameter
Interface —— The port selected to display the connective-status. By default, the
connective-status of all ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the connective-status of all Ethernet ports:
TP-LINK(config)# show interface status ethernet
show interface counters
Description
The show interface counters command is used to display the statistic
information of an Ethernet port.
Syntax
show interface counters ethernet [interface]
Parameter
Interface ——The port selected to display the statistic information. By default,
the statistic information of all ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the statistic information of Ethernet port3:
TP-LINK(config)# show interface counters ethernet 3