75
Chapter 16 IEEE 802.1X Commands
IEEE 802.1X function is to provide an access control for LAN ports via the authentication. Only the
supplicant passing the authentication can access the LAN.
dot1x (global)
Description
The dot1x command is used to enable the IEEE 802.1X function globally. To
disable the IEEE 802.1X function, please use no dot1x command.
Syntax
dot1x
no dot1x
Command Mode
Global Configuration Mode
Example
Enable the IEEE 802.1X function:
TP-LINK(config)# dot1x
dot1x auth-method
Description
The dot1x auth-method command is used to configure the Authentication
Method of IEEE 802.1X. To restore to the default 802.1x authe
ntication method,
please use no dot1x auth-method command.
Syntax
dot1x auth-method { pap | eap-md5 }
no dot1x auth-method
Parameter
pap | eap-md5 ——Authentication Methods.
PAP: IEEE 802.1X authentication system uses extensible authentication
protocol (EAP) to exchange information between the switch and the client. The
To Next Page
Loading...
Need help?
General
Weight and Dimensions
