TP-Link TL-SG5412F

79
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable the IEEE 802.1X function for the port 1:
TP-LINK(config)# interface ethernet 1
TP-LINK(config-if)# dot1x
dot1x guest-vlan
Description
The dot1x guest-vlan command is used to enable the Guest VLAN function for
a specified port. To disable the Guest VLAN function for a specified port, please
use no
dot1x guest-vlan command. Please ensure that
the Control Type of the
corresponding port is port-based before enabling the Guest VLAN function for it.
Please refer to dot1x port-method
for details.
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable the Guest VLAN function for port 2:
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# dot1x guest-vlan
dot1x port-control
Description
The dot1x port-control command is used to configure the Control Mode of
IEEE 802.1X for the specified port. To restore to the default configuration,
please use no dot1x port-control command.
Syntax
dot1x port-control { auto | authorized-force | unauthorized-force }