TP-Link TL-SG5412F

18
Example
Add port 2 to IEEE 802.1Q VLAN:
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# switchport allowed vlan add 2
switchport pvid
Description
The switchport pvid command is used to configure the PVID for the switch
ports.
Syntax
switchport pvid vlan-id
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
Command Mode
Interface Configuration Mode (interface ethernet / interface range ethernet )
Example
Specify the PVID of port 2 as 2:
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# switchport pvid 2
switchport general egress-rule
Description
The switchport general egress-rule command is used to configure the
egress-rule of the general port.
Syntax
switchport general egress-rule vlan-id { untagged | tagged }
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
untagged | tagged ——egress-rule，untagged or tagged
Command Mode
Interface Configuration Mode ( interface ethernet / interface range ethernet )
Example