TP-Link TL-SG5412F

19
Specify the egress-rule of port 2 in vlan 3 as tagged:
TP-LINK(config)# interface ethernet 2
TP-LINK(config-if)# switchport general egress-rule 3 tagged
show vlan
Description
The show vlan command is used to display the information of IEEE 802.1Q
VLAN .
Syntax
show vlan [vlan-id]
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094. By default , display all the
information of IEEE 802.1Q VLAN.
Command Mode
Any Configuration Mode
Example
Display the information of vlan 5:
TP-LINK(config)# show vlan 5
show interface switchport
Description
The show interface switchport command is used to display the IEEE 802.1Q
VLAN configuration information of the specified port.
Syntax
show interface switchport [port-num]
Parameter
port-num —— The port number. By default, display the VLAN configuration
information of all ports.
Command Mode
Any Configuration Mode
Example
Display the VLAN configuration information of all ports:
TP-LINK(config)# show interface switchport