TP-Link TL-SG5412F

121
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Disable the ingress-rate limit for port5:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# port rate-limit disable ingress
port rate-limit disable egress
Description
The port rate-limit disable egress command is used to disable the egress-rate
limit.
Syntax
port rate-limit disable egress
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Disable the egress-rate limit for port5:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)# port rate-limit disable egress
show interface configuration
Description
The show interface configuration command is used to display the
configurations of an Ethernet port, including Port-status, Flow Control,
Negotiation Mode and Port-description.
Syntax
show interface configuration ethernet [interface]
Parameter
interface —— The port selected to display the configurations. By default, the
configuration information of all ports is displayed.
Command Mode
Any Configuration Mode