TP-Link TL-SG5412F

123
show storm-control ethernet
Description
The show storm-control ethernet command is used to display the
storm-control information of an Ethernet port.
Syntax
show storm-control ethernet [port]
Parameter
port —— The port-number of the port selected to display the storm-control
information. By default, the storm-control information of all ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the storm-control information of all Ethernet ports:
TP-LINK(config)# show storm-control ethernet
show port rate-limit
Description
The show port rate-limit command is used to display the rate-limit information
of an Ethernet port.
Syntax
show port rate-limit [interface-num]
Parameter
port —— The port-number of the port selected to display the rate-limit
information. By default, the rate-limit information of all ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the rate-limit information of all Ethernet ports:
TP-LINK(config)# show port rate-limit