TP-Link TL-SG5412F

46
Parameter
value —— Port priority, ranging from 0 to 65535. By default, the value is 32768.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Set the port priority of port 1 to 1024:
TP-LINK(config)# interface ethernet 1
TP-LINK(config-if)# lacp port-priority 1024
show lacp system-priority
Description
The show lacp system-priority command is used to display the global system
priority value of LACP.
Syntax
show lacp system-priority
Command Mode
Any Configuration Mode
Example
Display the global system priority value of LACP:
TP-LINK(config)# show lacp system-priority
show lacp interface
Description
The show lacp interface command is used to display the port configuration
information of LACP.
Syntax
show lacp interface [ethernet port-num]
Parameter
port-num —— The Ethernet port number. By default, display the configuration
information of all the Ethernet ports.