6
Figure 1-4 Port Settings
6. Type the User name and Password in the Hyper Terminal window, the factory default value for
both of them is admin. The DOS prompt” TP-LINK>” will appear after pressing the Enter
button as figure1-5 shown. It indicates that you can use the CLI now.
Figure 1-5 Log in the Switch
1.1.2 Logon by Telnet
To log on to the switch by a Telnet connection, please take the following steps:
1. Make sure the switch and the PC are in the same LAN.
2. Click Start → Run to open the Run window.
To Next Page
Loading...
