181
snmp-rmon event owner
Description
The snmp-rmon event owner command is used to configure the owner of
SNMP-RMON Event. To return to the default configuration, please use no
snmp-rmon event owner command.
Syntax
snmp-rmon event owner {index} [owner]
no snmp-rmon event owner {index}
Parameter
index —— The index number of the event entry, ranging from 1 to 12. You can
only select one entry for each command.
owner —— The owner of the event entry, ranging from 1 to 16 characters. By
default, it is monitor.
Command Mode
Global Configuration Mode
Example
Configure the owner of entry 1 as owner1:
TP-LINK(config)# snmp-rmon event owner 1 owner1
snmp-rmon event enable
Description
The snmp-rmon event enable command is used to enable SNMP-RMON
Event entry. To disable the corresponding entry, please use no snmp-rmon
event enable command.
Syntax
snmp-rmon event enable {index}
no snmp-rmon event enable {index}
Parameter
index —— The index number of the entry desired to enable, ranging from 1 to
12, in the format of 1-3,5.
Command Mode
Global Configuration Mode
To Next Page
Loading...
