TP-Link TL-SG5428

127
Syntax
speed { 10 | 100 | 1000 | auto }
no speed
Parameter
10 | 100 | 1000 | auto —— The speed mode of the Ethernet port. There are
four options: 10Mbps, 100Mbps, 1000Mbps and Auto negotiation mode
(default).
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the Speed Mode as 100Mbps for port 3:
TL-SG5428(config)# interface gigabitEthernet 1/0/3
TL-SG5428(config-if)# speed 100
storm-control broadcast
Description
The storm-control broadcast command is used to enable the broadcast
control function. To disable the broadcast control function, please use no
storm-control broadcast command. Broadcast control function allows the
switch to filter broadcast in the network. If the transmission rate of the broadcast
packets exceeds the set bandwidth in the storm-control rate
, the packets will
be automatically discarded to avoid network broadcast storm.
Syntax
storm-control broadcast
no storm-control broadcast
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the broadcast control function for port 5:
TL-SG5428(config)# interface gigabitEthernet 1/0/5
TL-SG5428(config-if)# storm-control broadcast