TP-Link TL-SG5428 User Manual

11
Now you can manage your switch with CLI commands through Telnet connection.
Note:
You can refer to Chapter 10 User Manage Commands for detailed commands information of the
Telnet connection configuration.
1.2 CLI Command Modes
The CLI is divided into different command modes: User EXEC Mode, Privileged EXEC Mode,
Global Configuration Mode, Interface Configuration Mode and VLAN Configuration Mode.
Interface Configuration Mode can also be divided into Interface gigabitEthernet, Interface
link-aggregation and some other modes, which is shown as the following diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Mode Accessing Path Prompt Logout or Access the next mode
User EXEC
Mode
Primary mode once it
is connected with the
switch.
TL-SG5428>
Use the exit command to disconnect the
switch (except that the switch is
connected through the Console port).
Use the enable command to access
Privileged EXEC mode.
Privileged
EXEC Mode
Use the enable
command to enter this
mode from User EXEC
mode.
TL-SG5428#
Enter the disable or exit command to
return to User EXEC mode.
Enter configure command to access
Global Configuration mode.
Global
Configuration
Mode
Use the configure
command to enter this
mode from Privileged
EXEC mode.
TL-SG5428(config)#
Use the exit or the end command or
press Ctrl+Z to return to Privileged
EXEC mode.
Use the interface gigabitEthernet port
or interface range gigabitEthernet
port-list command to access interface
Configuration mode.
Use the vlan vlan-list to access VLAN
Configuration mode.

TP-Link TL-SG5428 Specifications

General

Brand	TP-Link
Model	TL-SG5428
Category	Switch
Language	English