130
no bandwidth { all | ingress | egress }
Parameter
ingress-rate —— Specify the bandwidth for receiving packets. Range:
1-1024000 for the gigaport.
egress-rate —— Specify the bandwidth for sending packets. Range:
1-1024000 for the gigaport.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the ingress-rate as 5120Kbps and egress-rate as 1024Kbps for port
5:
TL-SG5428(config)# interface gigabitEthernet 1/0/5
TL-SG5428(config-if)# bandwidth ingress 5120 egress 1024
clear counters
Description
The clear counters command is used to clear the statistic information of all the
Ethernet ports.
Syntax
clear counters
Command Mode
Global Configuration Mode
Example
Clear the statistic information of all ports
TL-SG5428(config)# clear counters
show interface status
Description
The show interface status command is used to display the connective-status
of an Ethernet port.
Syntax
show interface [ gigabitEthernet port ] status
To Next Page
Loading...
Need help?
General