214
no lldp transmit
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable port 1 to transmit LLDPDU:
TL-SG5428(config)# interface gigabitEthernet 1/0/1
TL-SG5428(config-if)# lldp transmit
lldp snmp-trap
Description
The lldp snmp-trap command is used to enable the port’s SNMP notification. If
enabled, the port will notify the trap event to network management system. To
disable the ports' SNMP notification, please use no lldp snmp-trap command.
Syntax
lldp snmp-trap
no lldp snmp-trap
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the SNMP notification for port 1:
TL-SG5428(config)# interface gigabitEthernet 1/0/1
TL-SG5428(config-if)# lldp snmp-trap
lldp tlv-select
Description
The lldp tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.
Syntax
To Next Page
Loading...
Need help?
General