TP-Link TL-SG5428

83
Syntax
dot1x port-control { auto | authorized-force | unauthorized-force }
no dot1x port-control
Parameter
auto | authorized-force | unauthorized-force —— The Control Mode for the port.
auto:
In this mode, the port will normally work only after passing the 802.1X
Authentication.
authorized-force: In this mode, the port can work normally without passing the
802.1X Authentication.
unauthorized-force: In this mode, the port is forbidden working for its fixed
unauthorized status.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the Control Mode for port 1 as authorized-force:
TL-SG5428(config)# interface gigabitEthernet 1/0/1
TL-SG5428(config-if)# dot1x port-control authorized-force
dot1x port-method
Description
The dot1x port-method command is used to configure the control type of IEEE
802.1X for the specified port. By default, the control type is “mac-based”. To
restore to the default configuration, please use no dot1x port-method
command.
Syntax
dot1x port-method { mac-based | port-based }
no dot1x port-method
Parameter
mac-based | port-based ——The control type for the port.
Mac-based: Any client connected to the port should pass the 802.1X
authentication for access.