30
port has been configured as the VPN Up-link port.
Syntax
switchport dot1q-tunnel mode uplink
no switchport dot1q-tunnel mode uplink
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the Gigabit Ethernet port 3 as the VPN Up-link ports:
TL-SG5428(config)#interface gigabitEthernet 1/0/3
TL-SG5428(config-if)#switchport dot1q-tunnel mode uplink
show dot1q-tunnel
Description
The show dot1q-tunnel command is used to display the global configuration
information of the VLAN VPN.
Syntax
show dot1q-tunnel
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the global configuration information of the VLAN VPN:
TL-SG5428(config)#show dot1q-tunnel
show dot1q-tunnel interface
Description
The show dot1q-tunnel interface command is used to display the
configuration information of the VLAN VPN of the interfaces.
Syntax
To Next Page
Loading...
