129
Enable the unicast control function for port 5:
TL-SG5428(config)# interface gigabitEthernet 1/0/5
TL-SG5428(config-if)# storm-control unicast
storm-control rate
Description
The storm-control rate command is used to configure storm control rate. To
disable the storm control function, please use no storm-control rate command.
Storm Control function allows the switch to filter broadcast, multicast and UL
frame in the network. If the transmission rate of the three kind packets exceeds
the set bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control rate rate
no storm-control rate
Parameter
rate —— The maximum ingress rate of the storm control packets. The packet
traffic exceeding the bandwidth will be discarded. The value of it can be 128k |
256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps.
Command Mode
Interface gigabitEthernet / Interface range gigabitEthernet
Example
Specify the storm control rate as 2Mbps for port5:
TL-SG5428(config)# interface gigabitEthernet 1/0/5
TL-SG5428(Config-if)# storm-control rate 2m
bandwidth
Description
The bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use no bandwidth
command.
Syntax
bandwidth {[ ingress ingress-rate ] [ egress egress-rate ]}
To Next Page
Loading...
Need help?
General