103
status —— Enable or disable the Port Security function for a specified port. By
default, this function is disabled.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable Port Security function for port 1, select Static mode as the learn mode,
and specify the maximum number of MAC addresses that can be learned on
this port as 30:
TL-SG5428(config)# interface gigabitEthernet 1/0/1
TL-SG5428(config-if)# mac address-table max-mac-count max-number 30
mode static status enable
show mac address-table address
Description
The show mac address-table address command is used to display the
information of all Address entries.
Syntax
show mac address-table address { dynamic | static | drop | all }
Parameter
dynamic | static | drop | all —— The type of your desired entry
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the information of all Address entries:
TL-SG5428(config)# show mac address-table address all
show mac address-table aging-time
Description
The show mac address-table aging-time command is used to display the
Aging Time of the MAC address.
Syntax
show mac address-table aging-time
To Next Page
Loading...
Need help?
General