169
default configuration of the corresponding Instance, please use no
spanning-tree mst configuration command.
Syntax
spanning-tree mst configuration
no spanning-tree mst configuration
Command Mode
Global Configuration Mode
Example
Enter into the MST configuration mode:
TL-SG5428(config)# spanning-tree mst configuration
TL-SG5428(Config-mst)#
instance
Description
The instance command is used to configure the VLAN-Instance mapping. To
remove the VLAN-instance mapping or disable the corresponding instance,
please use no instance command. When an instance is disabled, the related
mapping VLANs will be removed.
Syntax
instance instance-id vlan vlan-id
no instance instance-id [ vlan vlan-id ]
Parameters
instance-id —— Instance ID, ranging from 1 to 8.
vlan-id —— The VLAN ID selected to mapping with the corresponding
instance.
Command Mode
MST Configuration Mode
Example
Map the VLANs 1-100 to Instance 1:
TL-SG5428(config)# spanning-tree mst configuration
TL-SG5428(config-mst)# instance 1 vlan 1-100
Disable Instance 1, namely remove all the mapping VLANs 1-100:
TL- SG5428(config)# spanning-tree mst configuration
To Next Page
Loading...
Need help?
General