120
maxHops —— The maximum number of the route hops the test data can pass
though. It ranges from 1 to 30. By default, this value is 4.
Command Mode
User EXEC Mode and Privileged EXEC Mode
Example
Test the connectivity between the switch and the network device with the IP
192.168.0.131. If the destination device has not been found after 20 maxHops,
the connection between the switch and the destination device is failed to
establish:
TL-SG5428# tracert 192.168.0.131 20
loopback interface
Description
The loopback interface command is used to test whether the port is available
or not.
Syntax
loopback interface { gigabitEthernet port } { internal | external }
Parameter
port —— The number of Ethernet port which is selected for loopback test.
internal | external —— Loopback Type. There are two options, Internal and
External.
Command Mode
User EXEC Mode and Privileged EXEC Mode
Example
Do an Internal-type loopback test for port 1:
TL-SG5428# loopback interface gigabitEthernet 1/0/1 internal
Do an External-type loopback test for port 1:
TL-SG5428# loopback interface gigabitEthernet 1/0/1 external
show system-time
Description
To Next Page
Loading...
Need help?
General