113
contact_info —— Contact Information. It consists of 32 characters at most. It is
“www.tp-link.com” by default.
Command Mode
Global Configuration Mode
Example
Configure the system contact information as www.tp-link.com:
TL-SG5428(config)# contact-info www.tp-link.com
ip management-vlan
Description
The ip management-vlan command is used to configure the management
VLAN, through which you can log on to the switch. By default the management
VLAN is VLAN1.
Syntax
ip management-vlan {vlan-id}
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
Command Mode
Global Configuration Mode
Example
Set the VLAN6 as management VLAN:
TL-SG5428(config)# ip management-vlan 6
ip address
Description
The ip address command is used to configure the system IP Address, Subnet
Mask and Default Gateway. To restore to the factory defaults, please use no ip
address command. This command should be configured in the Interface
Configuration Mode of the management VLAN.
Syntax
ip address {ip-addr} {ip-mask} [gateway]
no ip address
To Next Page
Loading...
Need help?
General