TP-Link TL-SG5428 User Manual

71
ip arp inspection limit-rate
Description
The ip arp inspection limit-rate command is used to configure the ARP speed
of a specified port. To restore to the default speed, please use no ip arp
inspection limit-rate command.
Syntax
ip arp inspection limit-rate value
no ip arp inspection limit-rate
Parameter
value ——The value to specify the maximum amount of the received ARP
packets per second, ranging from 10 to 100 in pps(packet/second). By default,
the value is 15.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Configure the maximum amount of the received ARP packets per second as 50
pps for port 5:
TL-SG5428(config)# interface gigabitEthernet 1/0/5
TL-SG5428(config-if)# ip arp inspection limit-rate 50
ip arp inspection recover
Description
The ip arp inspection recover command is used to restore to the port to the
ARP transmit status from the ARP filter status.
Syntax
ip arp inspection recover
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)

TP-Link TL-SG5428 Specifications

General

Brand	TP-Link
Model	TL-SG5428
Category	Switch
Language	English