TP-Link TL-SG5428

66
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Set the Flow Control of port 2 as 20 pps:
TL-SG5428(config)# interface gigabitEthernet 1/0/2
TL-SG5428(config-if)# ip dhcp snooping limit rate 20
ip dhcp snooping decline
Description
The ip dhcp snooping decline command is used to enable the Decline Protect
feature. To disable the Decline Protect feature, please use no ip dhcp
snooping decline command.
Syntax
ip dhcp snooping decline
no ip dhcp snooping decline
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the Decline Protect feature of port 2:
TL-SG5428(config)# interface gigabitEthernet 1/0/2
TL-SG5428(config-if)# ip dhcp snooping decline
show ip source binding
Description
The show ip source binding command is used to display the
IP-MAC-VID-PORT binding table.
Syntax
show ip source binding