211
Chapter 30 LLDP Commands
LLDP function enables network devices to advertise their own device information periodically to
neighbors on the same LAN. The information of the LLDP devices in the LAN can be stored by its
neighbor in a standard MIB, so it is possible for the information to be accessed by a Network
Management System (NMS) such as SNMP.
lldp
Description
The lldp command is used to enable LLDP function. To disable the LLDP
function, please use no lldp command.
Syntax
lldp
no lldp
Command Mode
Global Configuration Mode
Example
Enable LLDP function globally:
TL-SG5428(config)# lldp
lldp hold-multiplier
Description
The lldp hold-multiplier command is used to configure the Hold Multiplier
parameter. The aging time of the local information in the neighbor device is
determined by the actual TTL value used in the sending LLDPDU. TTL = Hold
Multiplier * Transmit Interval. To return to the default configuration, please use
no lldp hold-multiplier command.
Syntax
lldp hold-multiplier multiplier
no lldp hold-multiplier
To Next Page
Loading...
Need help?
General