202
snmp-server traps mac
Description
The snmp-server traps mac command is used to enable SNMP extended
MAC address-related traps which include four types: new, full,
learn-mode-change and max-learned. To disable the sending of SNMP
extended MAC address related traps, please use no snmp-server traps mac
command.
Syntax
snmp-server traps mac [ new | full | learn-mode-change | max-learned ]
no snmp-server traps mac [ new | full | learn-mode-change | max-learned ]
Parameter
new —— Enable new MAC address trap. It is sent when the switch learns new
MAC address including dynamic address, static address and filter address.
full —— Enable MAC address table trap. It is sent when the MAC address table
is full.
learn-mode-change —— Enable MAC address learn-mode-change trap. It is
sent when MAC address learning mode of the switch changes.
max-learned —— Enable MAC address max-learned trap. It is sent when the
amount of learned MAC address reaches the limit which is configured in port
security module.
Command Mode
Global Configuration Mode
Example
Enable all SNMP extended MAC address-related traps for the switch:
TL-SG5428(config)# snmp-server traps mac
Enable new MAC address trap only for the switch:
TL-SG5428(config)# snmp-server traps mac new
snmp-server traps vlan
Description
The snmp-server traps vlan command is used to enable SNMP extended
VLAN-related traps which include two types: create and delete. To disable this
function, please use no snmp-server traps vlan command.
To Next Page
Loading...
Need help?
General