213
be sent out (the number of LLDPDUs equals this parameter). The value ranges
from 1 to 10 and the default value is 3.
Command Mode
Global Configuration Mode
Example
Specify the Transmit Interval of LLDPDU as 45 seconds and Trap message to
NMS as 120 seconds:
TL-SG5428(config)# lldp timer tx-interval 45
TL-SG5428(config)# lldp timer notify-interval 120
lldp receive
Description
The lldp receive command is used to enable the designated port to receive
LLDPDU. To disable the function, please use no lldp receive command.
Syntax
lldp receive
no lldp receive
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable port 1 to receive LLDPDU:
TL-SG5428(config)# interface gigabitEthernet 1/0/1
TL-SG5428(config-if)# lldp receive
lldp transmit
Description
The lldp transmit command is used to enable the designated port to transmit
LLDPDU. To disable the function, please use no lldp transmit command.
Syntax
lldp transmit
To Next Page
Loading...
Need help?
General