TP-Link TL-SG5428

215
lldp tlv-select [ port-description | system-capability | system-description |
system-name | management-address | port-vlan | protocol-vlan | vlan-name |
link-aggregation | mac-phy-cfg | max-frame-size | power | all ]
no lldp tlv-select [ port-description | system-capability | system-description |
system-name | management-address | port-vlan | protocol-vlan | vlan-name |
link-aggregation | mac-phy-cfg | max-frame-size | power | all ]
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Exclude “management-address” and “port-vlan-id” TLVs in LLDPDU outgoing
from port 1:
TL-SG5428(config)# interface gigabitEthernet 1/0/1
TL-SG5428(config-if)# no lldp tlv-select management-address port-vlan
show lldp
Description
The show lldp command is used to display the global configuration of LLDP
and LLDP-MED fast start repeat count number.
Syntax
show lldp
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the global configuration of LLDP and LLDP-MED fast start repeat count
number:
TL-SG5428# show lldp
show lldp interface
Description
The show lldp interface command is used to display LLDP and LLDP-MED
configuration of the corresponding port. By default, the configuration of all the