TP-Link TL-SG5428 User Manual

20
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Specify the Link Type of port 3 as trunk:
TL-SG5428(config)# interface gigabitEthernet 1/0/3
TL-SG5428(config-if)# switchport mode trunk
switchport access vlan
Description
The switchport access vlan command is used to add the desired Access port
to IEEE 802.1Q VLAN. To remove the specified port/ports from the
corresponding VLAN, please use no switchport access vlan command.
Syntax
switchport access vlan vlan-id
no switchport access vlan
Parameter
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 2 to 4094.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Specify the Link Type of port 3 as access and add it to VLAN 2:
TL-SG5428(config)# interface gigabitEthernet 1/0/3
TL-SG5428(config-if)# switchport mode access
TL-SG5428(config-if)# switchport access vlan 2
switchport trunk allowed vlan
Description
The switchport trunk allowed vlan command is used to add the desired Trunk
port to IEEE 802.1Q VLAN. To delete the corresponding VLAN(s), please use
no switchport trunk allowed vlan command.
Syntax
switchport trunk allowed vlan vlan-list

TP-Link TL-SG5428 Specifications

General

Brand	TP-Link
Model	TL-SG5428
Category	Switch
Language	English