TP-Link TL-SG5428 - Show Cluster Ndp; Show Cluster Ntdp

224
Syntax
cluster individual
Command Mode
Global Configuration Mode
Example
Specify the current switch as individual switch:
TL-SG5428(config)# cluster individual
show cluster ndp
Description
The show cluster ndp command is used to display NDP configuration of
certain ports.
Syntax
show cluster ndp [interface [ gigabitEthernet port ]]
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the NDP global configuration:
TL-SG5428# show cluster ndp
Display the NDP configuration of all Ethernet ports:
TL-SG5428# show cluster ndp interface
Display the NDP configuration of port 2:
TL-SG5428# show cluster ndp interface gigabitEthernet 1/0/2
show cluster ntdp
Description
The show cluster ntdp command is used to display NTDP configuration or the
information of device collected through NTDP.
Syntax
show cluster ntdp [ interface gigabitEthernet port | device-list ]