115
BOOTP Server. This command should be configured in the Interface
Configuration Mode of the management VLAN.
Syntax
ip address-alloc bootp
Command Mode
Interface Configuration Mode (interface vlan)
Example
Enable the BOOTP Protocol to obtain IP address from BOOTP Server when the
management VLAN of the switch is VLAN1:
TL-SG5428(config)# interface vlan 1
TL-SG5428(config-if)# ip address-alloc bootp
reset
Description
The reset command is used to reset the switch’s software. After resetting, all
configuration of the switch will restore to the factory defaults and your current
settings will be lost.
Syntax
reset
Command Mode
Privileged EXEC Mode
Example
Reset the software of the switch:
TL-SG5428# reset
reboot
Description
The reboot command is used to reboot the switch. To avoid damage, please
don’t turn off the device while rebooting.
Syntax
reboot
Command Mode
To Next Page
Loading...
