TP-Link TL-SG5428 User Manual

74
Chapter 13 IP Verify Source Commands
IP Verify Source is to filter the IP packets based on the IP-MAC Binding entries. Only the packets
matched to the IP-MAC Binding rules can be processed, which can enhance the bandwidth utility.
ip verify source
Description
The ip verify source command is used to configure the IP Verify Source mode
for a specified port. To disable the IP Verify Source function, please use no ip
verify source command.
Syntax
ip verify source {sip | sip+mac}
no ip verify source
Parameter
sip | sip+mac—— Security type. “sip” indicates that only the packets with its
source IP address and port number matched to the IP-MAC binding rules can be
processed. “sip+mac” indicates that only the packets with its source IP address,
source MAC address and port number matched to the IP-MAC binding rules can
be processed.
Command Mode
Interface Configuration Mode ( interface gigabitEthernet / interface range gigabitEthernet）
Example
Enable the IP Verify Source function for gigabitEthernet ports 5-10. Configure
that only the packets with its source IP address, source MAC address and port
number matched to the IP-MAC binding rules can be processed:
TL-SG5428(config)#interface range gigabitEthernet 1/0/5-10
TL-SG5428(config-if-range)#ip verify source sip+mac
show ip verify source
Description
The show ip verify source command is used to display the IP Verify Source

TP-Link TL-SG5428 Specifications

General

Brand	TP-Link
Model	TL-SG5428
Category	Switch
Language	English