TransAct Printrex 980 - Page 200

Appendix B: Frequently Asked Questions
Page 190 100-11672 - Rev D
Code
Detail Code
Item
Description
Action
1. Check Purge Unit movement.
2. Replace Purge Position Sensor.
06
40(MODULE1)
C0(MODULE2)
Condition
Detected
Purge Unit was not installed correctly
Action
1. Check Purge Unit movement.
2. Check Purge Position Sensor connection.
3. Check Purge Motor connector connection.
4. Replace Purge Position Sensor.
5. Replace Purge Motor.
6. Replace Purge Unit.
7. Replace Printer Controller PCB.
06
21(MODULE1)
A1(MODULE2)
Condition
Detected
Purge Unit position error
Action
Replace Purge Position Sensor.
06
41(MODULE1)
C1(MODULE2)
Condition
Detected
Purge Unit position error
Action
1. Check Purge Unit movement.
2. Check Purge Position Sensor connection.
3. Check Purge Motor connector connection.
4. Replace Purge Position Sensor.
5. Replace Purge Motor.
6. Replace Purge Unit.
7. Replace Printer Controller PCB.
06
23(MODULE1)
A3(MODULE2)
Condition
Detected
Purge Unit position error
Action
1. Check Purge Unit movement.
2. Check Purge Position Sensor connection.
06
43(MODULE1)
C3(MODULE2)
Condition
Detected
Purge Unit position error
Action
1. Check Purge Unit movement.
2. Replace Purge Motor.
3. Replace Purge Unit.
4. Replace Printer Controller PCB.
06
63(MODULE1)
E3(MODULE2)
Condition
Detected
Purge Unit position error
Action
1. Check Purge Unit movement.
2. Replace Purge Position Sensor.
3. Replace Purge Motor.
4. Replace Purge Unit.
5. Replace Printer Controller PCB.
06
24(MODULE1)
(MODULE2)
Condition
Detected
Purge Unit position error
Action
1. Check Purge Unit movement.
2. Replace Purge Position Sensor.
06
44(MODULE1)
C4(MODULE2)
Condition
Detected
Purge Unit position error
Action
1. Check Purge Unit movement.
2. Replace Purge Motor.
3. Replace Purge Unit.
4. Replace Printer Controller PCB.