TransAct Printrex 980 - Page 206

Appendix B: Frequently Asked Questions
Page 196 100-11672 - Rev D
Code
Detail Code
Item
Description
Action
1. Replace Print Module.
2. Replace Printer Controller PCB
08
38(MODULE1)
B8(MODULE2)
Condition
Detected
Bubble Removing Valve error
Action
1. Replace Print Module.
2. Replace Printer Controller PCB
08
78(MODULE1)
F8(MODULE2)
Condition
Detected
Bubble Removing Valve error
Action
1. Replace Print Module.
2. Replace Printer Controller PCB
09: Suction Pump Error
09
10(MODULE1)
90(MODULE2)
Condition
Detected
Internal state pressure error
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
12-15
(MODULE1)
92-95
(MODULE2)
*1
Condition
Detected
Ink Level Sensor does not detect ink
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
22-25
(MODULE1)
A2-A5
(MODULE2)
*1
Condition
Detected
Pressure does not change
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
32-35
(MODULE1)
B2-B5
(MODULE2)
*1
Condition
Detected
Pressure becomes lower too fast
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
16-19
(MODULE1)
96-99
(MODULE2)
*2
Condition
Detected
Ink Level Sensor does not detect air
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.