TransAct Printrex 980 - Page 207

Appendix A: Ordering Genuine Ithaca Supplies
100-11672 - Rev D Page 197
Code
Detail Code
Item
Description
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
26-29
(MODULE1)
A6-A9
(MODULE2)
*2
Condition
Detected
Pressure does not change
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
36-39
(MODULE1)
B6-B9
(MODULE2)
*2
Condition
Detected
Pressure becomes higher too fast
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
1A(MODULE1)
9A(MODULE2)
Condition
Detected
Pressure does not become lower
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
2A(MODULE1)
AA(MODULE2)
Condition
Detected
Pressure does not become lower
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
2B(MODULE1)
AB(MODULE2)
Condition
Detected
Pressure does not become higher
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.
09
41-4B
(MODULE1)
C1-CB
(MODULE2)
*3
Condition
Detected
Supply Valve status error when driving Pump
(dragging)
Action
1. Restart Printer in service mode, and then
load ink.
Service Utility > Troubleshooting > Ink Loading
2. Check the leakage of ink pass.
3. Replace Print Module.
4. Replace Printer Controller PCB.