TransAct Printrex 980 - Page 220

Appendix B: Frequently Asked Questions
Page 210 100-11672 - Rev D
Code
Detail Code
Item
Description
21: Ink Tank Installation Error
21
01-FF
(Additional
value
of K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value
of K:10,C:20,
M:40,Y:80)
(MODULE2)
Condition
Detected
Ink tank is not installed correctly.
Action
1. Install Ink Tank again, or replace with a new
Ink Tank.
2. Close all doors (error cleared).
22: Ink Tank Data Error
22
01-FF
(Additional
value
of K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value
of K:10,C:20,
M:40,Y:80)
(MODULE2)
Condition
Detected
Ink tank data error.
Action
1. Install a new Ink Tank.
2. Close all doors (error cleared).
23: Maintenance Cartridge Full
23
01
Condition
Detected
Maintenance Cartridge is detected full by
Leakage Sensor.
Action
1. Replace with a new Maintenance Cartridge.
2. Close all doors (error cleared).
24: Maintenance Cartridge Installation Error
24
01
Condition
Detected
Maintenance cartridge is not installed correctly.
Action
1. Install Maintenance Cartridge again or
replace with a new Maintenance Cartridge.
2. Close all doors (error cleared).
25: Maintenance Cartridge Data Error
25
01
Condition
Detected
Paper length is smaller than loaded print data.
Action
1. Replace with a new Maintenance Cartridge.
2. Close all doors (error cleared).
26: Ink Tank ID Error
26
01-FF
(Additional
value of
K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value
of K:10,C:20,
Condition
Detected
Correct Ink Tank is not installed.
Action
1. Replace with a correct Ink Tank.
2. Close all doors (error cleared).