TransAct Printrex 980 - Page 219

Appendix A: Ordering Genuine Ithaca Supplies
100-11672 - Rev D Page 209
Code
Detail Code
Item
Description
Action
1. Load paper correctly and close Upper Unit
(error cleared) or
2. Replace TOF Sensor
1D: Paper Jam Error 2
1D
01
Condition
Detected
TOF Sensor does not detect the trailing edge of
TOF mark while paper is fed from print pause
position to print start position.
Action
Remove jammed paper
1D
02
Condition
Detected
TOF Sensor does not detect the trailing edge of
TOF mark while paper is fed from print pause
position to print start position.
Action
Remove jammed paper
1D
03
Condition
Detected
TOF Sensor does not detect the trailing edge of
TOF mark while paper is fed from print pause
position to print start position.
Action
Remove jammed paper
1D
10
Condition
Detected
TOF Sensor does not detect TOF mark during
form feeding.
Action
1. Remove jammed paper.
2. Replace TOF Sensor.
1D
11
Condition
Detected
TOF Sensor does not detect TOF mark while
paper is fed forward to print position.
Action
1. Remove jammed paper or
2. Replace TOF Sensor.
1D
E1
Condition
Detected
Only 1% or less of encoder signal is received
even if Transport Motor is driven other than
during printing. (Transport Belts drive is not
transmitted to the encoder.)
Action
1. Removed jammed paper in Transport area
or
2. Replace Encoder Sensor.
1D
E2
Condition
Detected
Only 90% or less of encoder signal is received
during paper transport other than during
printing.
(Transport Belts are slipping on shafts.)
Action
1. Remove jammed paper in Transport area or
2. Replace Encoder Sensor.
3. Replace Transport Unit.
20: Ink Tank Empty
20
01-FF
(Additional
value
of K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value
of K:10,C:20,
M:40,Y:80)
(MODULE2)
Condition
Detected
Ink tank is empty.
Action
1. Replace with a new Ink Tank.
2. Close Ink Door (error cleared).