Ulvac GI-M2 - 5 Flow of Program Run

19
5.FLOW OF PROGRAM RUN
To set sensitivity factor, set points 1 and 2,
range, degas, filament, recorder and baud
rate, follow the instructions in Sections 8 and
higher. The initial setting can be made from
the front panel or RS-232C. Here, the
method of entry from the front panel is
described.
The flow of the display unit operation is as follows
Power is applied
Ｐ．
20
PRG Key
(2 sec.)
PRG key
(2 sec)
ＦＩＬ ＯＮ／ＯＦＦ Ｐ．
21
Sensor head selection
Ｐ．
27
ＤＥＧＡＳ ＯＮ／ＯＦＦ Ｐ．
22
Sensitivity factor setting
Ｐ．
28
Emission current
（
GI-N8 only
）
Ｐ．
23
Set point 1and 2 setting
Ｐ．
29
Range changeover
selection
Ｐ．
30
When pressure protection
is activated
Ｐ．
24
Range changeover
setting
Ｐ．
30
When EXT-PROTECT is
activated
Ｐ．
24
ＤＥＧＡＳ
selection
Ｐ．
31
ＤＥＧＡＳ
setting
Ｐ．
31
Filament
１／２
selection
Ｐ．
32
Analog selection
Ｐ．
33
Analog setting
Ｐ．
33
Activated filament
Ｐ．
34
Baud rate setting
Ｐ．
34
In this manual, procedures are shown with white characters on black background, as shown
below.
ＰＯＷ－①
[POW－①] means
ＰＯＷ－①
So refer to this item.
Turn off power
Check line
voltage.
Be cautious with
operationg
enbiroment
Refer to the page given at the end of each item for more
information.
Power off state
Measurement
mode
Program measurement
mode
WARNIN