31
8.9. Selection Of DEGAS Function
→ Refer to Ｐ．39
Setting of DEGAS function
ｄＧＳ：１ ⇒ ＭＡＮＵＡＬ MODE
ｄＧＳ：２ ⇒ ＡＵＴＯ MODE
The ○ portion in the left figure blinks
after the segment indicator displays [
] for about 1 second. Each
time the [∆] key is pressed, the ○
position on the segment indicator
displays [
] ⇔ [
]
cyclically.
To use DEGAS MANUAL, press the [⇒
(ENTER)] key, with [
]
selected, to transfer control to the FIL-①
status.
To use DEGAS AUTO, press the [⇒
(ENTER)] key, with [
]
selected, to transfer control to the DGS-
② status.
8.10. Setting of DEGAS Function
→ Refer to Ｐ．39
Set the numeric value of DEGAS auto OFF.
Settable numeric values are 01 to 99 minutes.
The ○ portion in the left figure blinks.
Each time the [∆] key is pressed, the
numeric value of the blinking portion
changes. When a desired numeric
value is displayed, press the [⇒
(ENTER)] key to transfer control to the
FIL-① status.
To Next Page
Loading...
