EasyManuals Logo

Unify OpenStage 40 User Manual

Unify OpenStage 40
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
104 Making calls in the team/executive/secretary configuration
The programmable sensor keys on multi-line phones function as line or trunk
keys. Every key programmed as a "Trunk key" (key label: Transfer
Trk)
corresponds to one trunk with the result that you can configure up to
six trunks
in OpenStage
40/40 G.
As a team member, you can independently program the following functions on
sensor keys
Æ Page 69:
Direct station select
Join/leave group
(not available on executive phone in an executive / secretary team)
Ring transfer: On/Off
(only in an executive/secretary team)
You can also program a sensor key with the function "Forward Line" (call
forwarding) for each line.
LED displays on trunk keys
Accepting calls with the trunk keys
Prerequisite: Your phone rings and/or a trunk key flashes quickly.
if nec. T Press the trunk key that is flashing quickly.
(not necessary for automatic trunk seizure/prime line is not active).
^ Lift the handset.
or On-hook dialing: Speakerphone mode.
Dialing with trunk keys
if nec. S Press the free trunk key you wish to use to establish the connection
(not necessary for automatic trunk seizure/prime line is not active).
j Dial the phone number.
^ If the party answers: Lift the handset.
or On-hook dialing: Speakerphone mode.
LED Meaning
S Off
The line is in idle mode.
T
Flashin
g
1
1 In this manual, flashing sensor keys are identified by this icon,
regardless of the flashing interval. The flashing interval represents
different statuses, which are described in detail in the
corresponding sections of the manual.
Incoming call on the line.
Hold reminder is activated.
The line is on "Hold".
R On
The line is busy.

Table of Contents

Other manuals for Unify OpenStage 40

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unify OpenStage 40 and is the answer not in the manual?

Unify OpenStage 40 Specifications

General IconGeneral
Resolution240 x 128 pixels
Full duplexYes
Camera includedNo
Dimensions (WxDxH)270 x 220 x 70 mm
Networking featuresQoS
Supported network protocolsIEEE 802.1Q (VLAN), IEEE 802.1p
Dialer locationBase
Phonebook capacity- entries
Volume controlDigital
Voice codecsG.711, G.722
Display number of lines6 lines
Display number of colorsMonochrome
Product colorBlack, Silver
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)5 - 40 °C
CertificationCE, EMC EN55022 Cl. B, EN55024, EN61000-4-11, EN61000-3-2, EN60950-1, EMC (FCC) P.15 (CFR 47) Cl. B, UL60950-1/CSA 22.2 No950
Weight and Dimensions IconWeight and Dimensions
Weight1068 g

Related product manuals