Unify OpenStage 40 User Manual

108 Making calls in the team/executive/secretary configuration
Deactivating call forwarding
N Open the Program/Service menu Æ Page 31.
Select and confirm the option shown.
Select and confirm the option shown.
R Press the required line key.
or
j Enter the required trunk number.
or
R If available, press the "CFW MULAP" key.
Understanding LED messages of the "CFW MULAP"
S The LED on the "CFW MULAP" key is off – call forwarding is not active for this
trunk.
or
R The LED on the "CFW MULAP" key lights up – call forwarding is active for this
trunk.
or
T The LED on the "CFW MULAP" key flashes slowly - the trunk is the destination
of call forwarding.
Destinations g
Forward Line: Off
If you have activated call forwarding for a trunk, a special dial tone sounds
when the line is seized.

Unify OpenStage 40 Specifications

General

Resolution	240 x 128 pixels
Full duplex	Yes
Camera included	No
Dimensions (WxDxH)	270 x 220 x 70 mm
Networking features	QoS
Supported network protocols	IEEE 802.1Q (VLAN), IEEE 802.1p
Dialer location	Base
Phonebook capacity	- entries
Volume control	Digital
Voice codecs	G.711, G.722
Display number of lines	6 lines
Display number of colors	Monochrome
Product color	Black, Silver
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	5 - 40 °C
Certification	CE, EMC EN55022 Cl. B, EN55024, EN61000-4-11, EN61000-3-2, EN60950-1, EMC (FCC) P.15 (CFR 47) Cl. B, UL60950-1/CSA 22.2 No950

Weight and Dimensions

Weight	1068 g