To Next Page

To Previous Page

8 Certiﬁcations

This chapter presents a range of different certiﬁcations and declarations that have been

prepared for the product.

8.1 Third Party Certiﬁcations

Third party certiﬁcations are voluntary. However, to provide the best service to robot

integrators, UR has chosen to certify their robots at the following recognized test insti-

tutes:

UV NORD UR robots are safety approved by T

UV NORD,

a notiﬁed body under the machinery directive

2006/42/EC in EU. A copy of the T

UV NORD

safety approval certiﬁcate can be found in ap-

pendix B.

DELTA UR robots are safety and performance tested by

DELTA. An electromagnetic compatibility (EMC)

certiﬁcate can be found in appendix B. An environ-

mental test certiﬁcate can be found in appendix B.

8.2 Declarations According to EU directives

EU declarations are primarily relevant for European countries. However, some coun-

tries outside Europe recognize or even require them, too. European directives are

available from the ofﬁcial homepage: http://eur-lex.europa.eu.

UR robots are certiﬁed according to the directives listed below.

2006/42/EC — Machinery Directive (MD)

UR Robots are partly completed machinery according to the Machinery Directive 2006/42/EC.

Note that a CE mark is not afﬁxed according to this directive for partly completed ma-

chinery. If the UR robot is used in a pesticide application, then note the presence of

directive 2009/127/EC. The declaration of incorporation according to 2006/42/EC an-

nex II 1.B. is shown in appendix B.

Version 3.1 (rev. 17782)

I-49 UR5/CB3

Universal Robots UR5 Original Instructions

Other manuals for Universal Robots UR5