10.3 Welcome Screen
10.3 Welcome Screen
After booting up the controller PC, the welcome screen is shown. The screen offers the
following options:
• Run Program: Choose and run an existing program. This is the simplest way to
operate the robot arm and control box.
• Program Robot: Change a program, or create a new program.
• Setup Robot: Set passwords, upgrade software, request support, calibrate the
touch screen, etc.
• Shutdown Robot: Powers off the robot arm and shuts down the control box.
CB3 II-8 Version 3.1 (rev. 17782)
Copyright © 2009-2015 by Universal Robots A/S. All rights reserved.
To Next Page
Loading...
Need help?
General
