Uponor Smatrix Wave PULSE User Manual

Channel
3 Public thermostat with outdoor sensor.
4 Public thermostat with heating/cooling switch from contact or,
heating cooling switch from sensor input (requires communication
module).
5 Public thermostat with Comfort/ECO switch from contact.This
option disables the Comfort/ECO option in the GPI.
5. Lock selected channel
SI0000071
Press the OK button to select the channel for registration. The LED
for the selected channel starts flashing green.
6. Register thermostat
5 s
SI0000074
Gently press and hold the registration button on the thermostat,
release when the LED starts flashing green (located in the hole
above the registration button).
The selected channel LED in the room controller turns fixed green
and the registration is complete.
7. Exit registration mode
3 s
SI0000078
Press and hold the OK button on the room controller until the green
LEDs turn off to end registration and return to run mode.
To unregister already registered thermostats, see Unregister room
controller channels, Page 77.
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
55

Uponor Smatrix Wave PULSE Specifications

General

Type	Wireless Temperature Controller
Communication Protocol	RF (Radio Frequency)
Compatibility	Uponor Smatrix Wave system
Operating Temperature Range	0°C to 50°C
Display	LCD
Control	Wireless